Fujitsu-siemens-computers BS2000/OSD Manual de usuario descargar pdf (Pagina 93)

U25339-J-Z126-1-7600 93

Troubleshooting Problems with the S130

8.1.2 Carrying out a system dump

Conditions:

1. Select the SVPST0 window

2. Select LD PROGRAM LOAD FRAME

3. Select LOAD FUNCTION => 5 (SYSTEM DUMP)

The system dump stored on hard disk or cassette by the DUMP program is required for

error diagnosis.

Afterwards, the BS2000/VM2000 system must be reloaded with the IPL.

Information on SLED operation can be found in the “Introductory Guide to Systems

Support“ [6] manual.

8.1.3 Measures to take in the case of defective I/O channels or I/O

processors

If an S130 channel or an added secondary I/O processor is defective, you can perform the

following after consulting the service department:

Ê Disable defective I/O channel during operation.

If an I/O channel has failed due to a hardware failure, it is automatically disabled. If not,

you can disable it using the BS2000 command DETË*CHA(XX).

Ê Disable defective I/O processor during operation.

If an I/O processor has failed due to a hardware failure, it is automatically disabled. If

not, you can disable it using the BS2000 command

/DETË*CHA(XX,YY)

when doing so, you should enter a list of channels CHPIDxx ,...,CHPIDyy; or enter a

range of channels from CHPIDxx to CHPIDyy using

/DETË*CHA-R(XX,YY)

You can continue processing with the other I/O processors until the repairs are carried

out by the service department. This is only possible if you can reach the peripheral

devices required for your work via non-defective I/O processors.

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 110 111

Sin comentarios

Fujitsu-siemens-computers BS2000/OSD Manual de usuario Pagina 93